Fast-dry, for interior general priming and exterior spot priming uses. Blocks stains from light water spots, graffiti, lipstick, crayon, grease, rust streaks, asphalt, pencil and mildew stains. Easy soap and water cleanup.
Use on bare or previously painted drywall, masonry, concrete, cured plaster, wood, non-rusted galvanized metal and gutters. Allow 2 hours before applying finish coat. Dries to the touch in 30 minutes. Gray tinted promotes better touch-up and uniform color, eliminating streaks.
Seals unpainted surfaces, providing a base for latex or oil-based finish coats. It dries quickly and is ready for re-coating in just a few hours. This primer will not raise the nap on wallboard, and it prevents flashing and hot spots from appearing in the finish coat. Apply it easily with a brush, roller or sprayer.
Seals unpainted drywall and plaster.
Fast-drying primer/sealer that will not raise the nap of drywall. Cleans up with water. Recommended for drywall, plaster and concrete block.
Recoat overnight. Breather film. For wood or hardboard. Blocks wood stains.
For new drywall. Fast drying. High hiding.
Seals surface. Extends life of top coat. Gives mildew resistant finish.
Formulated to penetrate and bond to properly prepared concrete to enhance adhesion of floor paints. Covers approximately 250 sq ft per gallon.
For general priming, multi-surface spot priming, blocks stains from smoke, fire, tannins, water, mildew, rust streaks, felt pen, ink, lipstick, pencil, crayon, graffiti and grease. Seals odor from smoke nicotine and pets. Sticks directly to glossy paint without sanding.
Use on new drywall, wallboard and previously painted walls, cured plaster and patching compound. Assures tight bonding and increased coverage of the finish coat. Dries to the touch in 30 minutes. Allow 2 hours before applying finish coat. White in color.
Enamel undercoater. Maximum adhesion.
Use as an under coat for all latex house paints. Provides long lasting protection and resistance to peeling and blistering. Maybe used on bare wood surfaces, previously painted wood siding and trim, brick, concrete, cement, stucco. Dries to touch in 30 minutes, Allow 2 hours before applying latex topcoats, overnight for oil topcoats.
Use to prime the whole house. Promotes adhesion of latex or oil-based topcoats. Gives mildew resistant coating. Fast drying.
Resists weather-related problems such as peeling and blistering. Mildew resistant coating that helps promote topcoat adhesion as it seals and primes exterior surfaces. Dries to the touch in 6-8 hours. Dry overnight before applying topcoat. Finish coat should be applied within 30 days following primer application. White in color.